4D modeling in a gimbaled linear accelerator by using gold anchor markers

Publication date: May–June 2018
Source:Reports of Practical Oncology & Radiotherapy, Volume 23, Issue 3
Author(s): Hideharu Miura, Shuichi Ozawa, Takaaki Matsuura, Atsushi Kawakubo, Fumika Hosono, Kiyoshi Yamada, Yasushi Nagata
PurposeThe purpose of this study was to verify whether the dynamic tumor tracking (DTT) feature of a Vero4DRT system performs with 10-mm-long and 0.28mm diameter gold anchor markers.MethodsGold anchor markers with a length of 10mm and a diameter of 0.28mm were used. Gold anchor markers were injected with short and long types into bolus material. These markers were sandwiched by a Tough Water (TW) phantom in the bolus material. For the investigation of 4-dimensional (4D) modeling feasibility under various phantom thicknesses, the TW phantom was added at 2cm intervals (in upper and lower each by 1cm). A programmable respiratory motion table was used to simulate breathing-induced organ motion, with an amplitude of 30mm and a breathing cycle of 3s. X-ray imaging parameters of 80kV and 125kV (320mA and 5ms) were used. The least detection error of the fiducial marker was defined as the 4D-modeling limitation.ResultsThe 4D modeling process was attempted using short and long marker types and its limitation with the short and long types was with phantom thicknesses of 6 and 10cm at 80kV and 125kV, respectively. However, the loss in detectability of the gold anchor because of 4D-modeling errors was found to be approximately 6% (2/31) with a phantom thickness of 2cm under 125kV. 4D-modeling could be performed except under the described conditions.ConclusionsThis work showed that a 10-mm-long gold anchor marker in short and long types can be used with DTT for short water equivalent path length site, such as lung cancer patients, in the Vero4DRT system.



from Imaging via alkiviadis.1961 on Inoreader http://ift.tt/2FT4NNj